#OPEN THE VIEWPORT SCREEN IN NCPLOT UPDATE#

You can now also remove more than one system variable at a time by selecting all variables to be removed and either pressing 'Del' or clicking the 'Remove System Variable' popup menu item. Enter the start and the end variable numbers separated by a dash like so: '5041-5044'. You can now add a range of variables when the 'Add System Variable' pop up menu item is clicked. Improved handling of system variables on the variable display window. This makes it much easier to see upcoming program blocks when stepping or animating through a program.

#OPEN THE VIEWPORT SCREEN IN NCPLOT UPDATE#

Whenever a line in a program is selected the program display will update so that the selected line is near the center of the program window whenever possible. You now have the option of cancelling program execution when the message is displayed.Д¬hanged the behavior for the program line highlighting. Updated the behavior for messages created by setting the system variable #3006. This will allow you to recover older versions of the file. Now when a file is saved the file being overwritten will be moved to the recycle bin before the file is saved. When manually adding system variables to the variable display window the maximum allowed variable number to add was fixed at 50000, this has been changed to the maximum variable number specified on the macro settings page.Д¬hanged the behavior for saving files.

In certain cases the 'Replace' tool will skip the next match after a replacement is made. The calculated move time was too low for moves where the spindle RPM was being clamped at either maximum or minimum RPM during the entire move. This bug only affected linear feed moves while constant surface speed was active. If the coordinate resolution setting was not '1.0' then this caused the 'K' 'Q' values to be incorrect.ДЇixed a bug in the run time estimation calculations for lathe. When the 'K' or 'Q' addresses were used in an M98 block their values were incorrectly being adjusted by the coordinate resolution setting. This page contains settings that allow you to configure NCPlot settings related to macro functions. The configurations that are included in NCPlot have been updated to the new search character, but if you have customized configurations then the wildcard characters will need to be updated manually.ДЄ new configuration page has been added called 'Macro B Settings'. The wildcard search character has been changed from the asterisk '*' to the question mark '?' in the interpreter customize list.

Open the viewport screen in ncplot